Filter
Top Products
Before starting
your dishwasher
1. Spin the Upper Spray Arm to make
sure nothing will stop it from turning
freely
2. Close and latch the door.
3. Run hot water at sink nearest dish-
washer until it is hot. Turn it off.
Clean
selector
Buttons
Starting your dishwasher
Option I
POTS & PANS Cycle...
1. Make sure Cycle Control Knob points
to dot marked POTS & PANS.
2. Push POTS & PANS Clean Selector
Button.
3. Push button for option desired.
4. Without turning it, pull out the Cycle
Control Knob to start the cycle.
HEAVY WASH Cycle...
1. Make sure Cycle Control Knob points
to dot marked HEAVY WASH.
2. Push HEAVY WASH button.
3. Push button for option desired.
4. Without turning it, pull out the Cycle
Control Knob to start the cycle.
NORMAL WASH Cycle...
1. Turn Cycle Control Knob clockwise
until it stops at dot marked NORMAL
WASH.
2. Push NORMAL WASH button,
3. Push button for option desired.
4. Without turning it, pull out the Cycle
Control Knob to start the cycle.
LOW ENERGY WASH Cycle...
4. Push LOW ENERGY WASH Button.
2. Turn Cycle Control Knob clockwise to
dot marked LOW ENERGY WASH.
3. Select option desired.
4. Without turning it, pull out the Cycle
Control Knob to start the cycle.
RINSE & HOLD Cycle...
1. Select AIR DRY Option only.
2. Turn Control Knob clockwise to dot
marked RINSE & HOLD.
3. Pull Control Knob out to start cycle.
Changing a setting
2. Turn the Cycle Control Knob clockwise to
the cycle you want
You can change a setting anytime during
any cycle
3. Be sure detergent dispensers are filled
1. Push in the Cycle Control Knob to stop the
properly for the new cycle.
4. Pull out the Cycle Control Knob to start the
cycle.
cycle.
To add a dish after starting
4. Close the door. Do not latch it. Wait 30 sec-
1. To be sure the added Item IS washed and
onds for air in the dishwasher to warm up.
rinsed, make sure the Cycle Control Knob
This helps reduce the amount of moisture
has not passed LOW ENERGY WASH
that can come from the vent when restari-
2. Unlatch the doorto stop the cycle, but don’t
ing the cycle.
open it until the spray arms stop spinning 5. Latch the door The dishwasher WIII start
3. Open the door and add the dish
from where it stopped
HI-TEMP WASHING Option
When this option is selected, water for the
main wash and the frnal rrnse is heated (except
in RINSE & HOLD] to 145 F (63 C). Washing and
rinsing action in those parts of the cycle will
be longer If the water is heated. HI-TEMP wash-
ing
IS
automatic in POTS & PANS.
a