Filter
Top Products
14
Canceling a Cycle
Anytime during a cycle, press
If your dishwasher has a dual-digit display, it shows
Your dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE:
If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
Changing a Cycle or Setting
During the first fill of a cycle
1.
Press a new cycle and/or options.
2.
Check the detergent dispensers. They must be filled properly
for the new cycle.
After the first fill of a cycle
1.
Press
If your dishwasher has a dual-digit display, it shows
Your dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE:
If your dishwasher does not need draining, the light
turns off.
2.
Check the detergent dispensers. They must be filled properly
for the new cycle.
3.
Close the door.
4.
Press a new cycle and/or options.
Adding Items During a Cycle
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1.
Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2.
Open the door. If the detergent dispenser cover is still closed,
add the item.
3.
Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5-second pause.
Option Selections
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off,
or select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
After a wash cycle, the dishwasher remembers the options used
and uses the same options in the next wash cycle, unless you
select new options or press Cancel/Drain.
Soak & Scour
Select this option to pre-soak your dishes for 4 hours in your
dishwasher instead of pre-soaking them in the sink. When you
select Soak & Scour, the dishwasher fills and then sprays for 8
minutes. It will then pause for 16 minutes while dishes soak, and
then spray for 90 seconds to keep dishes wet. Pausing for 16
minutes and spraying for 90 seconds are repeated for 4 hours. At
the end of the 4 hours, the dishwasher drains and then starts the
cycle you have selected. This pre-soaking uses only one
additional fill of water and does not require special detergent.
Use standard detergent per cycle recommendations.
If your dishwasher has a dual-digit display, it will show the hours
remaining in the soaking period before the cycle starts, beginning
with
showing 4 hours remaining.
NOTE:
Soak & Scour is an option for the Anti-Bacterial (available
on some models) or Pots & Pans cycles. If Hi-Temp Scour is also
selected, only the Soak & Scour option is actually used.