Before starting
your dishwasher
1. Spin the Upper Spray Arm to make sure
nothing will stop it from turning freely
2. Push door firmly when closing and it will
automatically latch.
3. Run hot water at sink nearest dishwasher
until it is hot. Turn it off.
Starting your dishwasher
1.
Push a Clean Selector Button for the de-
sired cycle.
2. Push Option Selector Button for desired
option or options. (Use AIR DRY for RINSE
& HOLD Cycle.)
3. Turn Cycle Control Knob clockwise to
point to a desired cycle. You will feel a
definite stop at each cycle mark.
CLEAN SELECTOR BUTTONS
I//
OPTION SELECTOR BUTTONS
-
POTS & PANS and HEAVY WASH Cycles
share the same spot on the dial. The
Clean Selector Button determines
which cycle operates.
The dishwasher will automatically start
the selected cycle.
The AIR DRY Option
Air in the dishwasher is automatically heated
during the “dry” part of all cycles.
If the AIR DRY Option is selected, air in the
dishwasher is not heated. Using this option helps
save energy, but dishes ta ke longer to dry (over-
night) and some water spotting may result.
Some items (such as plastics) may need towel
drying.
For best results, use a liquid rinse aid such as
Jet-Dry.@
HI-TEMP WASHING Option
When this option is selected, water for the
main wash and the final rinse is heated to145 F
(63-C).
continues without delay. The WATER HEATING
If the water is alreadv hot enouah. the cvcle
HOLD Signal Light will be on while the cycle de-
lays for water heating.
Using DELAY START
4. Close and latch the door. The DELAY WASH
Signal Light will come on until the selected
cycle starts.
NOTES:
l
You can add items while time is counting
down. Close and latch the door. The timer will
not advance if the door is unlatched.
l
RINSE & HOLD and LOW ENERGY WASH Cycles
can’t be delayed.
1. Push desired Clean Selector Button.
2. Push desired Option Selector Buttons.
3. Turn Control Knob clockwise to the number of
hours (from 1 to 6 hours] you want the dish-
washer to delay before the selected cycle
starts.
To add a dish after starting
4. Close the door. Do not latch it. Wait 30 sec-
1. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob
has not passed LOW ENERGY WASH.
2. Unlatch the doorto stop the cycle.
3. Open the door and add the dish.
onds for air in the dishwasher to warm up.
This helps reduce the amount of moisture
that can come from the vent when restart-
ing the cycle.
5. Latch the door. The dishwasher will start
from where it stopped.
The CLEAN Signal Light
To turn it off. Turn the Control Knob clockwise
The CLEAN Signal Light will come on when a slightly until the light goes off. Do not pull out
washing cycle is complete.
the Control Knob.
8