Filter
Top Products
Before starting
your dishwasher
1. Spin the Upper Spray Arm to make
sure nothing will stop it from turning
freely.
2. Close and latch the door.
3. Run hot water at sink nearest dish- cI
washer until it is hot. Turn it off.
Clean Selector Buttons
Starting your dishwasher
1. Push a Clean Selector Button for the
desired cycle.
2. With the Cycle Control Knob pushed
in, turn it to point at the desired cycle -
you will feel a definite stop at each
cycle mark.
-POTS & PANS and HEAVY WASH
Cycles share the same spot on the
dial. The Clean Selector Button de-
termines which cycle operates.
-LOW ENERGY WASH and CHINA
CRYSTAL Cycles share the same
spot on the dial. The Clean Selector
Button determines which cycle
operates.
3. Push Option Selector Button for de-
sired option or options. (Use AIR DRY
for RINSE & HOLD Cycle.)
4. Pull out the Cycle Control Knob to start
the cycle.
The AIR DRY Option
Air in the dishwasher is automatically heated
during the “dry” part of all cycles.
If the AIR DRY Option is selected, air in the
dishwasher is not heated. Using thisoption helps
save energy, but dishes take longer to dry [over-
night] and some water spotting may result.
Some items (such as plastics) may need towel
drying.
Open the door long enough for steam to
escape. Close the door to allow the Cycle
Control Knob to complete its cycle.
HI-TEMP WASHING Option
When this option is selected, water for the
main wash and the final rinse is heated - ex-
If water is already hot enough, the cycle
continues without delay. The WATER HEATING
HOLD Signal Light will be on while the cycle
delays for water heating.
cept in RINSE HOLD Cycle - to 145°F (63°C).
Using DELAY START
1. Push Cycle Selector Button.
2. Push Option Selector Button for desired op-
4. Pull out the Control Knob. The DELAY START
Signal Light will come on until theselected
cycle starts.
NOTES:
tion or options,
3.
l
You can add items while time is counting
With the Control Knob pushed in, turn clock-
down. Close and latch the door. The timer
wise to the number of hours [from 1 to 6
will not advance if the door is unlatched.
hours] you want the dishwasher to delay
l
RINSE & HOLD, LOW ENERGY WASH and
before the selected cycle starts.
CHINA CRYSTAL Cycles can’t be delayed.
To add a dish after starting
4. Close the door. Do not latch it. Wait 30 sec-
1. To be sure the added item is washed and
onds for air in the dishwasher to warm up.
rinsed, make sure the Cycle Control Knob
This helps reduce the amount of moisture
has not passed LOW ENERGY WASH.
that can come from the vent when restart-
2. Unlatch the doorto stop the cycle, but don’t
ing the cycle.
open it until the spray arms stop spinning.
5. Latch the door. The dishwasher will start
3. Open the door and add the dish.
from where it stopped.
The CLEAN Signal Light
To turn it off. Turn the Control Knob clockwise
The CLEAN Signal Light will come on when a slightly until the light goes off Do not pull out
washing cycle is complete. the Control Knob.
8