Filter
Top Products
\
CYCLE CONTROL KNOB
LOW ENERGY Cycle
For pre-rinsed or lightly soiled loads.
Cycle time is about 53 minutes,
RINSE & HOLD Cycle
For rinsing a few items to be washed
one or more days later. Cycle time is
about 12 minutes.
Use AIR DRY only.
HEAT DRY or AIR DRY?
If the HEAT DRY Option is selected, air in the
dishwasher is heated during the “dry” part of
save energy, but dishes ta ke longer to dry (over-
the cycle.
night) and some water spotting may result.
Some items (such as plastics) may need towel
If the AIR DRY Optton is selected, air in the drying.
dishwasher is not heated. Using this option helps
For best results, use a liquid rinse aid such as
Jet-Dv
Changing a setting
You can change a setting anytime during
3. Be sure the detergent dispensers are filled
any cycle.
properly for the new cycle.
1. Lift up on the door latch to unlatch the door
4. Press door firmly to latch it. The dishwasher
and stop the cycle. Don’t open the door until
will automatically start the new cycle.
the spray arms stop spinning.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
To add a dish after starting
1. To be sure the added item is washed and
4. Close the door. Do not latch it. Wait 30 sec-
rinsed, make sure the Cycle Control Knob
has not passed LOW ENERGY WASH.
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that
2. Lift up on the door latch to unlatch door to
can come from the vent when restarting the
stop the cycle. Don’t open the door until the
cycle.
spray arms stop spinning.
5. Press door firmly to latch it. The dishwasher
3. Open the door and add the dish.
will automatically start where it stopped.