Filter
Top Products
Operating Instructions
Continued
Starting your dishwasher
1.
Push a Cycle Selector Button for the desired
cycle. Normal Wash, Low Energy Wash and
Rinse & Hold Cycles share the same button.
The Cycle Control Knob determines which
cycle operates.
2. Push an Option Selector Button for each
desired option. (Use Air Dry Option for Rinse
& Hold Cycle.)
3. Turn the Cycle Control Knob clockwise to
point to a desired cycle. You will feel a definite
stop at each cycle mark. The dishwasher will
automatically start that cycle.
NOTE: If the door is latched, you will hear cycles
start and stop as the knob passes each cycle
mark. This is normal and will not hurt the dish-
washer. If you prefer, you can set cycles with the
door unlatched.
To add a dish after starting
1. To be sure the added item is washed and
rrnsed, make sure the Cycle Control Knob has
not passed LOW ENERGY WASH.
2. Lift up on the door latch to unlatch door and
stop the cycle. Don’t open the door until the
spray arms stop spinning.
3. Open the door and add the dish.
4.
Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that can
come from the vent when restarting the cycle.
5. Press door firmly to latch it. The dishwasher will
automatically start where It stopped.
Changing a cycle setting
You can change a setting anytime during
any cycle.
1. Lift up on the door latch to unlatch the door and
stop the cycle. Don’t open the door until the
spray arms stop spinning.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
3. Be sure the detergent dispensers are filled
properly for the new cycle.
4. Push door firmly to latch It. The dishwasher will
automatrcally start the new cycle.
Changing an option
If you want to change a selected option, push the
RESET OPTIONS Button. Re-select an option,
if desired.