Filter
Top Products
Before starting your dishwa
1. Read “Important Safety Instructions” on page
2 before starting your dishwasher.
2. Spin the Upper and Lower Spray Arms to
make sure nothing will stop them from turning
freely.
3. Push door firmly when closing and it will auto-
matically latch.
4. Run hot water at sink nearest dishwasher until
it is hot. Turn it off.
Starting your dishwasher
1. Push a Clean Selector Button for the desired
cycle.
2. Push Option Selector Button for desired option
or options. (Use AIR DRY for RINSE & HOLD
Cycle.]
3. Turn Cycle Control Knob clockwise to point to
a desired cycle.You will feel a definite stop at
each cycle mark.
.sher
,
(~~‘1’1’1’1’1’1’1’11’1111111111111
CLEAN SELECTOR BUllONS OPTION SELECTC
-POTS & PANS and HEAVY WASH Cycles share
the same spot on the dial. The Clean Selec-
tor Button determines which cycle it
operates.
- NORMAL WASH, LOW ENERGY WASH and
RINSE & HOLD Cycles share the NORMAL
WASH Clean Selector Button. The Cycle
Control Knob setting determines which cy-
cle will operate.
The dishwasher will automatically start the
selected cycle.
The AIR DRY Option
Air in the dishwasher is automatically heated
night] and some water spotting may result.
during the “dry” pari of all cycles.
Some items (such as plastics) may need towel
If the AIR DRY Option is selected, air in the
drying.
dishwasher is not heated. Using this option helps
For best results, use a liquid rinse aid such as
save energy, but dishes take longer to dry (over-
Jet-Dry.8
HI-TEMP WASHING Option
When this option is selected, water for the
main wash and the final rinse is heated (except
in RINSE & HOLD] to 145°F (63°C). Washing and
rinsing action in those parts of the cycle will
be longer if the water is heated. HI-TEMP wash-
ing is automatic in POTS & PANS.
If water is already hot enough, the cycle
continues without delay. The WATER HEATING
HOLD Signal Light will be on while the cycle
delays for water heating.
Changing a setting
You can change a setting anytime during any
cycle.
1. Lift up on the door latch to unlatch the door
and stop the cycle. Don’t open the door until
the spray arms stop spinning.
3. Be sure the detergent dispensers are filled
properly for the new cycle.
4. Press door firmly to latch it. The dishwasher
will automatically start the new cycle.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
To add a dish after starting
1.
To be sure the added item is washed and
rinsed, make sure the ADD A DISH Signal Light
is ON.
2. Lift up on the door latch to unlatch the door
and stop the cycle. Don’t open the door until
the spray arms stop spinning.
3. Open the door and add the dish.
8
4. Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that
can come from the vent when restarting the
cycle.
5. Latch the door. The dishwasher will start
from
where it stopped.