Filter
Top Products
Common dishwashing problems
PROBLEM
CAUSED BY
SOLUTION
Spottlng and
tllmlng
[hard water film]
Small particles
deposlted on
items
Dishes not dry
Black marks on
dlshes
Chipping or
breaking
glassware
Hard water
Water is not
hot enough
Not enough
detergent, or
Improper detergent
“Old” detergent
Improper loadrng
No rrnse old
AIR DRY Settrng used
Spray arm or arms not
rotatrng freely
“Old” detergent
Not enough
detergent, or
improper detergent
Water IS not hot
enough
Water pressure may
be low, dishwasher IS
not filling properly
Water IS not hot
enough
Improper loadrng
No rrnse old
AIR DRY Settrng used
Alumrnum utensils
rubbrng against items
dunng washing
Improper loading
Fill detergent dispensers to capacrty. Use dishwasher de-
tergent with highest avarlable phosphorus content. May
be necessary to install water softener.
To remove spots and film, try a vinegar rinse...
1. Wash and rinse load as usual. Use AIR DRY.
2 Remove all metal items.
3. Put 2 cups (500 mL) white vinegar in a container on the
bottom rack.
4. Run drshwasherthrough a complete washing cycle.
Water temperature should be at least 14O’F (60°C). Set
water heater thermostat to a higher setting. Run water at
srnk until hot before startina and/or use HI-TEMP WASH
Option.
Use more dishwasher detergent. Use detergent with high-
est available phosphorus content. especially with hard
water.
Use only fresh dishwasher detergent. Store tightly closed
container, in cool, dry place. Discard old detergent. Do not
fill dispensers until ready to start dishwasher.
Make sure dishes and glassware are loaded so spray
reaches all surfaces and Items dram properly Do not ov-
erload Do not nest items
Make sure large items do not block spray from reaching
detergent dispensers
Does the rrnse aid dispenser need filling? See Instructions
on page 7.
Dryrng without heat may result In some spotting of glasses
and silver
Check spray arms to make sure they turn freely after load-
ing Be sure a utensil has not prevented theirturnrng
Use only fresh dishwasher detergent. Store tightly closed
container, in cool, dry place. Discard old detergent. Do not
fill dispensers until ready to start dishwasher.
Use more dishwasher detergent Use detergent with high-
est avarlable phosphorus content especially with hard
water
Water temperature should be at least 140 F (6O’C). Set
water heater thermostat to a higher setting. Run water at
sink until hot before startrng and/or use HI-TEMP WASH
Option
If water pressure IS low, do not use water for other purposes
while dishwasher IS running (to assure correct fills).
Water temperature should be at least 140-F (60°C). Set
water heater thermostat to a higher setting Run water at
sink untrl hot before starting and/or use HI-TEMP WASH
Option
Make sure dishes and glassware are loaded so spray
reaches all surfaces and items drain properly. Do not ov-
erload Do not nest Items
Fill rinse aid dispenser
Allow more time when using AIR DRY Option, or use HEAT
DRY Plastic items may need towel drying.
Use care in loadlng alumlnum utensils, especially any
llghtwelght foil container. Place so they do not touch
dlshes. Remove black marks with plastic scouring pad
and a mild abrasive cleanser.
Do not overload Load glasses in the top rack only. Load
between prongs, not over them. Glasses loaded over
prongs will not be supported and may chip or break.