Filter
Top Products
Electrical Shock Hazard
Disconnect refrigerator from
main power supply. Failure
to do so could result in elec-
trical shock.
CONNECTING ICE MAKER
TO FREEZER WALL
2
Remove Plugs and -
Cover From Freezer
Wall
\
\
I
’ ’
I /‘,/’
TUBE COVER
Snap off wrrrng/enlrance tab
INTERIOR
TUBE COVER
save reuse rn step 4
JUNCTION BOX wd
Remove WIRING
HOLE COVER
I , /
Remove WATER FILL COVER
Remove screws
3
Remove Plugs From -
Refrigerator Back
Pul wrring assembly (Xl 939029). black plug
end first loreen wrre on too). lhrouah lower I
Y
I- ~- or,
hole on back of refngerator.
Install Water Tube -
R2 (836489)
WATER TUBE
SEAL GASKET
FITTING
Slip TUBE over
WATER INLET
Green wire
must be on lop.
Reinstall INTERIOF
(about 4-5 inches of wiring assembly
should be in Ihe freezer compartment.)
And Shield’
Attach clip #6 (536533)
and screw X7 (469069)
through each of top 2 holes
in shield Leave screws loose.
CLIPS should slay
uprighl until ICE MAKER
is in place on SHIELD.
WARNING-DO NOT PINCH WIRES BETWEEN
BRACKET AND SIDE OF FREEZER.
LIPS down and trghlen SCRE
ow ICE BUCKET
can be slid under
7
Connect Water Line -
Between Water Valve
r/ _ (With SCREW)
TAN WIRE
STIC TUBE ASSEMBLY X16
709) (Feeds under
c WIRING ASSEMBLY