Filter
Top Products
CONNECTING ICE MAKER
76 FREEZER WALL
2
Remove Plu
s And-
Cover From
B
reezer
REMOVE i PLUGS FROM SQUARE
HOLES (1 SEE ARROWS).
FOR TOP AND
BOlTOM MOUNT
FREEZER
SLIP TUBE
#l (Part No 636490)
OViR WATER INLEi
TUBE-PUSH ON.
FOR SIDE-BY-SIDE
FREEZER
SLIPTUBE #l (Part No. 636175)
OVER WATER
INLET TUBE-ENGAGE FIRMLY
CURVED END TO
POINT TOWARD
CENTER OF FREEZER
‘ater Fill Tubr
4
Install W
Grommet
TOP AND BOTTOM
I
SIDE-BY-SIDE -
MOUNT FREEZER
FREEZER MODELS
MODELS AFTER ALUMINUM FILLTUBE IS IN PLACE, SLIDE
GROMMET #2 (Parl No. 835649) OVER TUBE-
SNAP INTO PLACE.
SNAP SCREW
GROMMET #3(Parl No. 502037)
INTO PLACE IN BOTTOM
SQUARE HOLE
\
6
Insert Sliding Adapt=
Plug Into Rear of Ice
Maker
-REMOVE KNOCK-OUT FROM END OR
SIDE POSITIONS AS INDICATED.
TOP AND
BOmOM MOUNl
FREEZER
TJ
MODELS
SIDE-BY-SIDE
FREEZER
MODELS
PLUG-IN CONNECTOR
TO RECEPTACLE ON
ICE MAKER
WHILE HOLDING ICE MAKER,
PUSH CLIPS THAT ARE MOUNTED
ON SIDE INTO SQUARE
HOLES AND PUSH DOWN
FIRMLY UNTIL ICE
MAKER STOPS