Filter
Top Products
Installation Steps
These instructions cover models with and without a condenser coil
on the back of the cabwat. See illustrations below and
follow instructions that apply to your model.
Tools and Other Items You Will Need
TOOIS Water Hook Uo
l-Phillips head screwdriver (Materials needed. not included in Ice Maker Kit.)
I-Pliers T/4” 00. Copper Tubing-See step 2 (back page)
l--‘/4” nut driver
for length.
or l-shut-off Valve--W” outlet.
6” flat blade screwdriver l-Tube Union--C” x 1%”
?
Remove 2 Screws
(save
for reuse)
Remove Water Fill Cow
11
Plastic Tube
Connection _
Place Clamp onto inlet
tube.
Place tube insert in end
of tube and slide into
inlet tube, tighten clamp.
NOTE: Excess tube can
be cut off; be sure to
allow line to go into tube
for full length of insert.
10
Attach Wire
and Water
Tube Clamps _
!
I
<,
3
Install
4
Tube
4
Install Wiring Harness
- Remove wiring hole cover. Pull insert pad from
cabmet hole and place around wires
’ Push wiring harness #l into hole, being sure
grommet seals flush to prevent air entry.
Connect plug firmly into receptacle.
Route wires behind condenser coils if present.
INSTALL WATER VALVE
Connect valve wiring plug onto
,5 terminals on valve coil.
Attach plastic water tube
assembly #14. Push tubing into
valve and tiohten nvlon nut lnot
I/
loo tiahtl on; valve’threads.
Attach Ground Wire (Green Wire)
with Self Tapping Screw #12.
Attach Valve
with Self Tapptng Screw #fz
and clamp with Sheet Metal Screw #9.
12
Remove Plugs and Cover
from Freezer Wall.
14
Attach Ice Maker to Freezer Wall