Filter
Top Products
Installation Steps
These ~nstrucl~ons cover models with and wIthout a condenser coil
on the back of the cabinet. See lll”strat1ons below and
follow InstructIons that apply to your model
Tools and Other Items You Will Need
TOOIS
Water Hook
Up
1 -Phllllps head screwdriver (Mater& needed, not Included I” Ice Maker KII )
1 -Plws 1%” 0 D. Copper Tubing-See step 2 (back page)
l--‘/4” nut driver for length.
or
1 -Shut-off Valve-K outlet
V flat blade screwdriver 1 -Tube Umon--1/e” x ‘(4”
11
Plastic Tube
Connection -
Place Clamp onto Inlet
tube.
Place lube insert I” end
of tube and slide lnto
bnkl tube, tIghten clamp.
NOTE, Excess tube can
be cul off, be sure to
allow lone to 90 inlo tube
lor full lenglh of insert
10
Attach Wire
and Waler
Tube Clamps -
1
Unplug Electric Plug
From Outlet
1
.
Remove 2 Screws
(save for WS~)
YQ.-.-
’ Remove Water FIII Cover
03
Install Water Tube
&tall Wiring Harness
Remove wlnng hole cover. Pull mserl pad from
cabhnet hole and place around wres.
1 Push wwng harness #l lnlo hole. being wre
grommet seals flush to prevenl air entry
Connect plug llrmly Into receptacle
Roule w,res behlnd condenser Coils If present
INSTALL WATER VALVE
15
Connect valve w,nng plug onto
terminals on valve coil.
Altach plaslic water lube
assembly #14. Push tubmg Into
valve and tighten nylon nut (not
IOO
light) onto valve threads
t
l!f
ks
Tighten hose
Connector of
copper lube lo
water valve
being sure to
point tube
straighl up.
Attach Ground Wire (Green Wire)
with Self Tapping Screw #12.
Attach Valve
wth Sell Tapping Screw #12
and clamp with Sheet Metal Screw #9
12
Remove Plugs and Cover
from Freezer Wall.
14
Attach Ice Maker to Freezer Wall