Filter
Top Products
Raise
signal
arm to
stop ice.
Lower
signal
arm to
start it.
For crushed ice, cubes are crushed before being
dispensed. This rnay cause a slight delay when
dispensing crushed ice. Noise from the ice crusher
is normal, and pieces of ice may vary in size.
When changing from CRUSHED to CUBE, a
few ounces of crushed ice will be dispensed along
with the first cubes.
To dispense
water:
I. Press a sturdy glass against the water
dispenser bar.
2. Remove the glass to stop dispensing.
NOTE:
Dispense enough water every week to
maintain a fresh supply.
Chilled water comes from a tank behind the meat
drawer. It holds about 1% quarts (1.5 L).
When the refrigerator is first hooked up, press
the water dispenser with a glass or jar until you
have drawn and &carded 2 or 3 quarts (1.9 to
2.8 L). The water you draw and discard will rinse
the tank and pipes.
Allow several hours to chill the first tankful.
NOTE: The smal’ tray beneath the dispenser is
designed to evaplorate
small
spills. There is no
drain in this tray. Do not pour water into it.
WATER
LIGHT
TO turn on night light, slide dispenser LIGHT
switch to the left. See page 9 for directions for
changing dispenser light.
Automatic ice maker
Here are a few things you will want to know about
your automatic ice maker.
l
The ON/OFF lever is a wire signal arm.
Down.. .for making ice automatically.
Up.. .to shut off the ice maker.
NOTE: Do not turn ice maker on until it is con-
nected to the water supply. Instructions for
ice maker water supply hook-up are
attached to the back of the refrigerator
cabinet.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
The ice maker will not operate until the freezer is
cold enough to make ice. This can take
overnight.
l
If ice is not being made fast enough and more ice
is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, if necessary, turn
the Freezer Control toward C.
l
Good water quality is important for good ice
quality. It is not recommended that the ice maker
be connected to a softened water supply. Water
softener chemicals such as salt from a malfunc-
tioning softener can damage the ice maker mold
and lead to poor quality ice. If a softened water
supply cannot be avoided, then it is important
that the water softener be well maintained and
operating properly.
11