Using Your Refrigerator
Continued
Automatic ice maker
Here are a few things you will want to know about
your automatic ice maker:
l
The ON/OFF lever is a wire signal arm.
Down.. .for making ice automatically.
Up...to shut off the ice maker.
NOTE: Do not turn ice maker on until it is
connected to the water supply.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
l
If ice is not being made fast enough and more ice
is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, if necessary, turn
the Freezer Control toward C.
l
Good water quality is important for good ice
quality. It is not recommended that the ice maker
be connected to a softened water supply. Water
softener chemicals such as salt from a malfunc-
tioning softener can damage the ice maker mold
and lead to poor quality ice. If a softened water
supply cannot be avoided, then it is important
that the water softener be well maintained and
operating properly.
Raise
signal
arm to
stop ice.
Lower
signal
arm to
start it.
Removing ice maker storage bin
Remove, empty and clean the storage bin:
l
If the ice dispenser has not, or will not, be used
for a week or more;
l
If a power failure causes ice in the bin to melt and
freeze together;
l
If the ice dispenser is not used regularly.
1. Pull the covering panel out from the bottom and
slide it to the rear.
12