Filter
Top Products
2. Lift the signal arm so it clicks into the OFF
position. Ice can still be dispensed, but no more
will be made.
3. Lift the front of the storage bin. Pull it out.
4. Empty the bin. Use hot or warm water to melt
the ice if necessary. Never use anything
sharp to break up ice in the bin. This can
damage the bin and dispenser mechanism.
5. Wash with mild detergent. Rinse well. Do not
use harsh or abrasive cleansers or solvents.
6. When replacing the bin, make sure it is pushed
in all the way. Push the signal arm down to the
ON position to restart ice production.
Chip
collection
e tray
7. Periodically remove the chip collection tray
below the ice bin and wipe out excess water
and ice chips. Pull down firmly with both hands
to remove tray. Replace tray by pushing tabs up
into metal clips. Tray should snap into place.
Clip Clip
I
Chip collection
tray
TO turn on night light, slide dispenser LIGHT
switch to the left. See page 9 for directions for
changing dispenser light.
13