Filter
Top Products
Install properly..
I
I I
Allow room to open Hd
I
2 Inches at back
I*
I
I[=
I
1 Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Allow at least 3 inches (7.5 tin) air space on all
sides of freezer and 2 inches (5 cm) at back. Leave
room at top for lid to open all the
way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad-
justment, see your authorized service agency.
5. Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
If required by sanitation code, seal the cabinet to the
floor with the approved floor seal kit. This kit.(Part No.
702509) can be purchased from your Whirlpdol Ap-
pliance Dealer or from Whirlpool Corporation,
LaPorte Division,1900 Whirlpool Drive, LaPorte, Indiana
Level chest freezer...
from end to end and front to back so that the lid will
seal properly.
Check with level
Clean it . . .
Clean your freezer befo
using it. See cleaning
Instructions on page 6.
Plug it in...
3-prong grounding
type wall receptacle
Retainitg
Clip
eF
Freezer Y
Power Cord
grounding plug
Recommended Groundlng Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended thai a separate circuit serving only
this appliance be provided.
Use a receptacle
which cannot be turned otl wlth a switch or pull
chain. Do not use an extenslon cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.
4