Filter
Top Products
Plug It In...
j-prong groundlng
type wall receptacl
Freezer
power cord
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused
electrical supply is required. It is recommended
that a separate circuit serving only this appliance
be provided. The receptacle should not be con-
trolled by a wall switch or pull chain.
Attach retaining clip over power cord plug from
the literature package inside your freezer. Do not
use an extension cord.
Using your freezer
Setting the Cold Control...
1. Insert a coin in the slot of the Cold Control to
turn it.
2. Turn control to Number 3. This setting will main-
tain zero zone temperatures under normal op-
erating conditions.
Adjusting Cold Control.. .
l
Turn control to higher number for colder
temperatures.
l
Turn to lower number for less cold temperatures.
Cooling Freezer FM...
l
Allow freezer to cool 6 to 8 hours before filling
with frozen food.
l
Let it cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freezer lid is opened.
After the cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
proper temperature.
The outside of your freezer may feel warm. This
is normal. The freezer’s design and main function
is to remove heat from packages and air space
inside the freezer. This heat is transferred to the
room air so the walls of the freezer may be warm.
Key Eject lock...
The key eject lock can help reduce the hazard
of child entrapment.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer
for a replacement.
Sliding Basket...
can be moved from side to side when load-
ing or unloading food below it. The basket also
can be lifted out of the freezer completely.