Filter
Top Products
Install properly..
Remove sales labels...
-l~,l-A~L
!
1
I
I
1
1
Allow room to open Ild
1
I
w
2
Inches at back
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachioride, etc. These can damage the
material.
3 inches
3 inches
4lr
I, Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Allow at least 3 inches (7.5 cm] air space on all
sides of freezer and 2 inches (5 cm] at back. Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad-
justment, see your authorized WHIRLPOOL dealer.
5. Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level chest freezet..
from end to end and front to back so that the lid will
seal properly
NOTE: DO NOT REMOVE the Care 81 Service label
on inside lid or Tech Sheet on back of cabinet.
Clean it...
Clean your freezer before
using it. See cleaning
instructions on page 6.
Plug it in...
type wall receptacle
Refainin\g Clip
Freezer
/
Power Plug
grounding -plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.
4