Whirlpool EL11SC Freezer User Manual


 
Install properly...
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re-
frigerator. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5 cm] between the re-
frigerator condenser on the back and the wall
3. Allow li2 inch (1.25 cm) on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against c wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
Level refrigerator-freezer. . .
LEVE
LEG
RAISE
LOWER
1. Keep the 4 bolts that held refrigerator in ship-
ping crate. They are the levelling legs.
2. Screw these bolts all the way into bolts holes at
the bottom corners of refrigerator.
3. Adjust each leg until the refrigerator won’t rock.
Slide refrigerator into place.
4. Adjust front legs to level the refrigerator.
-To raise corners, turn legs in direction shown.
-To lower corners, turn legs in direction shown.
5. Check with level.
Clean it...
Clean your refrigerator before plugging it in or
using it. See cleaning instructions on page 7.
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD
3-PRC
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere tused
and properly grounded electrical supply is
required. It is recommended that a separate cir-
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See Individual electrical requirements
and grounding instruction sheet in your literature
package
l
Move Run Switch to RUN.
NOTE: The refrigerator motor will not operate
until the Run Switch is on RUN.
4