Whirlpool ET16AKXL Refrigerator User Manual


 
Tilt the Front;
Lift the Back
, Push in the Ceder;
Pull Down
Push the lab
to Clear the Cover
Snap Back Into Place
Raise Signal
Arm to Stop Ice Maker
lower Signal
Arm to Start II.
Adjusting the Shelves and Meat Pan.
Arrange your refngerator shelves and meat pan to suit yourself.
You can put two shelves together to make one full-width shelf, or put
them on different levels.
To remove them, tilt up at the front. Then lift up at the back. When
replacing them, keep them tilted; guide the rear hooks into the slots
in the shelf bracket. Lower the front.
Before moving the meat pan itself, remove the pan by pulling it
out, lifting the front and then pulling out the rest of the way.
Reversing the Door Swing.
You can change the hinges on your refrigerator so the doors open
the other way. If you rearrange your kitchen or move your refrigera-
tor to a new kitchen, you might like your doors to open the other way.
Refer to the enclosed instruction sheet.
Removing the light Shield.
You may want to remove the light shield when cleaning, or for
changing the bulb. First, unplug the refrigerator. Then, push lightly on
the upper center of the shield until the notched tab is free from the
console. Pull down until the tab clears, then lift the back hooks out of
their slots.
To replace it, do the reverse.
Removing the Crispers and Crisper Covers.
To remove the crispers, slide them out until they stop. Lift the front a
little and slide them the rest of the way out.
Each cover is held in place by two pegs at the back and two
notched tabs in the front. Press the tabs out of the way to lift the front.
Lift the back off the pegs.
To put the covers back, replace the center leg. Replace each
cover by first fitting the back notches over the pegs. Then push the
front down into the notched tabs.
The center leg can be made shorter or longer to help level the
crisper covers, if necessary. Turn the leg clockwise to make it longer.
Turn it counter-clockwise to shorten it.
ICE MAGIC” Automatic Ice Maker.
If you have the automattc Ice maker accessory or plan to add one later
(Part No. ECKMF-6). there are a few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Down...for making Ice automattcally,
Up. .toshut off the Ice maker.
l
Shake the bin occasionally to keep cubes separated. and to obtain
increased storage capacity.
l
It IS normal for ice crescents to be attached by a corner. They will break
apart easily.
l
You will hear water running when ice maker IS working. You’ll hear ice
fall Into the bin Don’t let these sounds bother you.
l
The Ice maker will not operate until the freezer IS cold enough to make
ice. This can take overnight.
l
Because of new plumbing connections, the first Ice may be discolored
or off-flavored. Discard the first few batches of ice.
l
If ice is not being made fast enough and more ice is needed, turn the
Temperature Control toward a higher number. Walt a day and, if nec-
essary, turn the Air Control toward A.
l
If you remove the ice bin, raise the signal arm to shut off the ice maker.
When you return the bin, push It all the way in and lower the arm to the
ON position
l
If cubes are stored too long, they may develop on off-flavor...like stale
water. Throw them away. They will be replaced. Cubes in the ice bin
can also become smaller by evaporation