Filter
Top Products
Install properly.. .
Remove sales labels.. .
il
I I
lla
1 Allow 3 inches (7.5 cm] between overhead cabi-
nets and refrigerator top.
2 Allow at least an inch (2.5 cm] between the
refrigerator condenser on the back and the wall.
3 Allow
%
inch (1.25 cm) on each side of the
refrigerator for ease of installation.
4. If the refrigerator IS to be against a wall, you mrghl
want to leave extra space on the hinge side so the
door can be opened wrder
Level refrigerator-freezer.. .
Leveling screw
Rdlse 1
Lower
Use Screwdriver
to Adjust
Right to Raise
Left to Lower
1. To raise front. turn each screw to the rrght.
2 To lower front, turn each screw to the left
3. Check with level.
Remove the Consumer Buy Guide label, tape and
any
lnslde
labels before using the refrigerator
To remove any remalnlng glue:
I, Rub briskly with thumb to make a ball then remove
OR
2. Soak area wrth dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refriqerator
before using it. -
See cleanrng instructrons
on page 8.
Plug it in...
J-prong grounding
type wall receptacle
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4