Filter
Top Products
Install properly.. .
11
I I
,L
I---
L-J
r
1 Allow 3 inches (7 5 cm] between overhead cable
nets and refrigerator top
2 Allow at least an Inch (2 5 cm) between the
refrigerator condenser on the back and the wall
3 Allow ‘,!. Inch (1 25 cm) on each side of the
refrtgerator for ease of lnstallatlon
4 If the refrigerator IS to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
Level refrigerator-freezer...
Raise
tower
This refrigerator has 2 threaded levelllng legs that
are shipped in a separate package
1. Screw these legs all the way Into bolt holes in the
bottom front corners of the refrigerator
2 Slide the refrigerator Into place
3 Adjust front legs to level the refrigerator
-
To raise corners, turn legs In direction shown
-
To lower corners, turn legs in direction shown
4 Check with level
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution [I
teaspoon detergent tn 1 quart warm water] before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
I
ggg$
-\
Clean your refrigerator
,I
,,
before using It
/n
See cleaning InstructIons L
on pages 7 and ,8
Plug it in...
3-prong
grounding type
wall receptacle
11111
3-drong
1)
grounding plug
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fuseu
and properly grounded electrlcal supply IS re-
quired It IS recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See lndlvidual electrical require-
ments and grounding InstructIon sheet In your liter-
ature package
A