Filter
Top Products
Before Using Your
Refrigerator
I
In This Section
Page
I
Cleaning it
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Installing it properly . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Plugging it in
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Leveling it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
It is important to prepare your refrigerator for us8. This section tells you how to clean it,
connect it to a power source, install it and level ft.
Cleaning it
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining glue:
l
Rub briskly with your thumb to make a ball,
then remove.
OR
l
Soak area with liquid handdishwashing
detergent before removing glue as de-
scribed above. Do not us8 sharp instru-
ments, rubbing alcohol, flammable fluids or
abrasive Ckan8rS. Th8S8 can damage the
material. Se8 “Important Safety Instruc-
tions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging mater&,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 17 and 18.
Plugging it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electriil
supply is required. lt is recommended that a
separate circuit sewing only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
See Electriil Requirements and Ground-
ing Instructions Sheet in your Liierature
Package.
3-prong grounding
type wall receptacle
Ref rigerato
power cord
grounding plug
5