Filter
Top Products
Removing the base grille...
To remove the grille:
METAL CLIPS
1. Open the door.
2. Pull grille outwards as shown.
3. Do not remove Tech sheet fastened behind
grille.
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the door.
Ice compartment door...
w.
Pull the ice compartment door panel out from the
bottom and slide it to the rear.
NOTE: Make sure the ice compartment shelves
are In place.
Ice cube trays...
(Model ET22DK only)
If cubes are not used, they may shrink. The mov-
ing cold air starts a slow evaporation. The longer
cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends
2. Slightly twist.
Automatic ice maker...
If you have Model ET22DM and have the auto-
matic ice maker accessory, or if you have Model
ET22DK and plan to add one later (Part No.
ECKMF-B3), there are a few things you will want to
know:
l
The ON/OFF lever is a wire signal arm.
Down...for making ice automatically.
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
l
The dial or lever on the side of the ice maker
changes the size of the cubes.
l
You will hear water running when ice maker is
working. You’ll hear ice fall into the bin. Don’t let
these sounds bother you.
l
The ice maker will not operate until the freezer
8
NAL
ICE
is cold enough to make ice. This can take
overnight.
l
Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard
the first few batches of ice.
l
If ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control to-
ward a higher number. Wait a day and, if neces-
sary, turn the Freezer Control toward A.