Filter
Top Products
Adjusting the refrigerator shelves...
To remove the shelves:
1.
First, remove food from shelf.
2. Slide shelf straight out to the stop.
3. Lift front, slide shelf the rest of the way out.
To replace the shelves:
1.
Fit back of shelf on top of guides with wire stops
on the bottom of guides.
2. Lift front, slide shelf in until it clears guide stops.
GUIDE
Removing crispers and crisper cover...
To remove the crispers:
1.
Slide crisper straight out to the stop.
2. Lift the front.
3. Slide the rest of the way out.
4. Replace in reverse order.
To remove the cover:
1.
Lift front and remove the cover support.
2. Lift out cover by pulling up and out.
To replace the cover:
1.
Fit back of cover into notch supports on walls of
refrigerator, then lower front into place.
2. Replace cover support with the long tab toward
the front.
NOTE: if the support needs adjust-
ment, turn base right to raise, or left to lower.
Changing the light bulb...
ry&
1.
Reach behind the control console to find bulb.
2. Remove bulb.
3. Replace with a
40-watt appliance bulb.
Reversing the door swing...
You can change the hinges on your refrigerator
so the doors open the other way. You will need a
#20 Torx head screwdriver. Refer to the instruction
sheet included with your refrigerator.
- I
To remove ice:
1.
Hold tray at both ends.
2. Twist slightly.
Ice cube trays...
(Model ETWK)
If cubes are not used, they may shrink. The mov-
ing cold air starts a slow evaporation. The longer
cubes are stored, the smaller they get.
6