Filter
Top Products
Install properly.. .
Remove sales labels.. .
.
Remove the Consumer Buy Guide label, tape and
any
Inside
labels before using the refrigerator.
To remove any remalnlng glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solutron (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrlgemtor at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on page 0
1 Allow 3 inches (7.5 cm) between overhead cabi-
nets and refrigerator top.
2. Allow at least an inch [2 5 cm] between the
refrigerator condenser on the back and the wall
3. Allow
%
inch (1.25 cm) on each side of the
refrigerator for ease of installatron.
4 If the refrigerator is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
-m=i*l*lm
Level refrigerator-freezer.. .
Leveling screw
Use Screwdriver
Right to Raise;
Lefl to Lower
to Adjust
1. To raise front, turn each screw to the right
2. To lower front, turn each screw to the left
3. Check with level.
Plug it in...
j-prong grounding
type wall receptacle,
Retrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off wlth a switch
or pull ohaln.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.