Filter
Top Products
1.
Allow 3 inches (7.5 cm] between overhead cab-
inets and refrigerator top.
2. Allow at least an inch (2.5 cm) between the re-
frigerator condenser on the back and the wall.
3. Allow Yz inch (1.25 cm) on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
Level refrigerator-freezer...
USE SCREWDRIVER
TO ADJUST
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any
inside
labels before using the re-
frigerator.
To remove any remainlng glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrlgemtor at the front.
Clean it...
Clean your refriger-
ator before using it.
See cleaning instruc-
tions on page 9. p
I
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
LEVELLING SCREW
RIGHT TO RAISE;
LEFT TO LOWER
1.
To raise front, turn each screw to the right.
2. To lower front, turn each screw to the left.
3. Check with level.
REFRIGERAiOR
3-PRONG -
POWER CORD
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir-
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off wlth a switch or
pull chain.
See individual electrical reguirements
and grounding instruction sheet in your literature
package.