Filter
Top Products
Using Your Freezer
Continued
Light shield
The interior light
Electrical Shock Hazard
Before removing a light bulb, either unplug
the freezer or disconnect the electricity
leading to the freezer at the main power
supply. Shock and injury can occur if elec-
tricity remains connected.
To replace the light:
1. Disconnect freezer from power supply.
2. Remove the light shield from the side of the
control panel. Depress the back of the shield to
release the tabs, then pull away.
3. Replace the bulb with a 40-watt appliance bulb.
4. Replace the light shield. Insert the shield
tabs in the slots, then press the shield to snap
into place.
5. Reconnect power supply.
The signal light
The signal light automatically warns of any
unexpected power failure.
If the signal light is not glowing, immediately
check for power interruption, an unplugged power
cord or a burned out signal light.
To replace signal light:
1. Disconnect freezer from power supply.
2. Open the freezer door.
3. Push out signal light from behind, then
unplug burned out light. Replace with a
new one. Signal light can be ordered from
your Whirlpool dealer, Part No. 1103639.
4. Close freezer door and reconnect power supply.