Filter
Top Products
Install properly...
Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
Pick a safe place, indoors, away from in-
flammables such as gasoline.
Allow 3 inches [ 7.5 cm) air space on top of freezer
for proper ventilation.
Allow at least an inch (2.5 cm) between the
freezer condenser, on the back of the unit, and
the wall.
Allow % inch (1.25 cm] on each side of the freezer
for ease of installation.
If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
Level freezer...
so the door will stay >
open at any position.
Start ad)ustment with the door hinge side.
1, Slide the freezer into place,
2. Adjust front legs to level the freezer
- To raise front, turn legs clockwise.
-To lower front, turn legs counterclockwise.
3. Check with level.
4. After freezer is fully loaded, recheck with level
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside
labels before using the freezer.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be-
fore removing glue as described in step I,
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachioride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the treezer at the front.
Clean it...
Clean your freezer befo
using It. See cleaning
instructions on page 6.
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only
this appliance be provided.
Use a receptacle
which cannot be turned off wtth a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer,