Filter
Top Products
Using Your Freezer
Continued
Light shield
The trivet
Store small packages in basket to avoid losing
them in bottom of freezer.
To remove:
1. Lift front of trivet out of supports
2. Pull out.
To replace:
I. Position back of trivet on the rear wall supports.
2. Lower front into place.
The key eject lock
If your freezer is equipped with a lock, it can help
reduce the hazard of child entrapment.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock
If the key is lost, contact your Whirlpool dealer
for a replacement. Always give the complete
model and serial number of your freezer when
requesting a replacement key.
The interior light
Electrical Shock Hazard
Before removing a light bulb, either unplug
the freezer or disconnect the electricity
leading to the freezer at the main power
supply. Shock and injury can occur if elec-
tricity remains connected.
To replace the light:
1. Remove the light shield from the side of the
control panel. Depress the back of the shield to
release the tabs, then pull away.
2. Replace the bulb with a 40-watt appliance bulb.
3. Replace the light shield. Insert the shield
tabs in the slots, then press the shield to snap
into place.
The signal light
The signal light automatically warns of any
unexpected power failure.
If the signal light is not glowing, immediately
check for power interruption, an unplugged power
cord or a burned out signal light.
To replace signal light:
1. Unplug power cord from outlet.
2. Open the freezer door.
3. Push out signal light from behind, then
unplug burned out light. Replace with a
new one. Signal light can be ordered from
your Whirlpool dealer, Part No. 1103639
(EVl SOFXS) or Part No. 1103680
(EVl SOFXS).
4. Close freezer door and plug power cord into
outlet.