Filter
Top Products
Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial.
This setting will maintain zero zone temperatures
under normal operating conditions.
Adjusting Cold Control...
l
Turn control to higher number for
temperatures.
colder
l
Turn to lower number for less cold temperatures.
Cooling Freezer First.. .
l
Allow freezer to cool 6 to 8 hours before filling
with frozen food.
l
Let it cool overnight before adding large
amounts of unfrozen food.
l
Frost will form on the shelves. It will form first and
be heavier on the top shelves.
Note: When freezer is first started the compressor
will run Iconstantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on loon‘) temperature and the number of times
the free,!er door is opened.
After t?e CaPinet is cooled the compressor will
turn on ‘and off as needed to keep freezer at
proper temperature.
I===
POWER SAVING CONTROL
‘5 AV E S
POWER
MOISTURE
OFF
ON
The Power Saving Control...
operc:tes electric heaters. These heaters help
prevent moisture from forming on the outside of
the freezer when humidity is high.
l
Use th!i: OFF setting when humidity is low to save
electrlN:ity.
l
Use ON only if moisture forms on outside of
freezer.
Exterior Signal light . . .
automatically warns of any unexpected power
failure.
To replace burned out signal light:
1. Unplljg power cord from outlet.
2. Remove base grille. See page 4.
If the signal light is not glowing, immediately
3. Unplu;d burned out light and replace with one
check:
of sari>>> wattage and size. Signal light can be
l
for power interruption,
orderli>d from your WHIRLPOOL dealer, Part No.
l
the power cord; it may be disconnected from
530584.
the outlet,
4. Replace base grille. See page 4.
l
the signal light; it may be burned out.
5. Plug F ‘ower cord into outlet.
3