Filter
Top Products
Before You Call For Service
If you are having an operating problem,
check the chart to see what the cause
might be before you call for assistance.
OPERATING PROBLEM
CHECK IF
WHAT TO DO
--
Nothing operates.
1 The power cord is plugged into a live
1 Plug the power cord into a live cixuit
circuit with proper voltage.
with proper voltage. (See Installation
Instructions.)
l
Range is properly connected to gas
1 Contact an authorized Roper service
supply.
technician to reconnect range to
~JC~S
supply. (See Installation Instructions.)
Oven will not operate.
Burner fails to light.
. Household fuse has blown or circuit
n
Replace fuse or reset circuit breaker.
breaker has tripped.
. Control knob is set in the correct
l
Set control knob correctly, if needed.
position.
1 The flow of combustion and/or ventila-
1 Remove blockage to airflow to and
tion air to the range is blocked.
around range.
--
. Oven Temperature Control is turned to
n
Push in and turn Oven Temperature
a temperature setting.
Control to the desired temperatine
setting, if needed.
n
Pilot is extinguished on standing pilot
1 Light pilot, (See “Lighting standing
model.
pilots” on page 5.)
--
. The power cord is plugged into a live
I Plug the power cord into a live ci :cuit
circuit with proper voltage.
with proper voltage. (See Installation
Instructions.)
1 Household fuse has blown or circuit
n
Replace fuse or reset circuit brea Ier.
breaker has tripped.
. Burner ports are clogged.
m Clean with a straight pin (see pages i
and 9).
1 Pilot is extinguished on standing pilot
1 Light pilot, (See “Lighting standing
model.
pilots” on page 5.)
--
Burner flames are uneven.
. Burner ports are clogged.
n
Clean with a straight pin (see pages 7
and 9). If this fails, call an author.zecl
Roper service technician for servce.
--
Burner flames lift off ports, are
1 Contact an authorized Roper service
yellow, or are noisy when
technician to check air/gas mixture
turned off.
--
Burner makes popping noise
1 Burner is wet from washing.
. Let dry.
when on.
--
Control knob(s) will not turn.
. You pushed in knob(s) before trying to
1 Push in knob(s) before turning to a
turn.
setting.
--
Cooking results are not what
. The range is level.
1 Level range. (See Installation
you expected.
Instructions.)
1 The oven temperature seems too high
m Adjust the Oven Temperature Control
or too low.
(See “Adjusting the oven temperatun?
control” on page 6.)
1 The oven was preheated as the recipe
1 Preheat the oven if called for in t E
calls for. recipe.
. You are following a tested recipe from
1 Use only tested recipes from a reliahlr?
a reliable source.
source.
. Pans are the type and size called for in
m Refer to a reliable cookbook for
the recipe. recommended pan types and sizes.
1 When baking, there is proper air
. Allow 1% to 2 inches (4-5 cm) on all
circulation around pans.
sides of the pans for air circulation.
1 Flame size fits the cooking utensil
1 Adjust flame size to fit cooking utensil.
being used.
1 When broiling, you have completely
closed the broiler drawer.
1 Completely close broiler drawer.
--
Page 11