Filter
Top Products
Water Dispenser
(select models)
If you did not flush the water system when the refrigerator was first
installed, dispense water into a container until you draw and discard 8
to 12 L (2 to 3 gal.) or for approximately 6 to 7 minutes after the water
begins dispensing. The water you draw and discard rinses the pipes.
Allow several hours for the refrigerator to cool down and chill water.
Dispensing Water
I. Hold a container under the dispenser while pressing the button.
2. Release the button to stop dispensing.
NOTE: Dispense enough water every week to maintain a fresh
supply.
User Preferences
The control center allows you to set user preferences, if desired.
Temperature Display (CF)
This preference allows you to change the temperature display.
(2 - Temperature in degrees Celsius
F- Temperature indegrees Fahrenheit
Alarm (bILL)
This preference allows you to turn offthe sound of all alarms.
ON - You will hear the alarm sound.
OFF - You will not hear the alarm sound.
Sabbath Mode (SAB)
IMPORTANT: This preference does not disable interior lights.
ON - All control panel lights will be disabled.
OFF - All control panel lights will be enabled.
NOTE: Press any touch pad on the control panel to restore the
control panel lights.
To Access the User Preferences Menu:
I. Press and hold the Door Alarm touch pad for 3 seconds. The
preference name will appear inthe Freezer display and the
preference status ((2 or F) or (ON or OFF) will appear in the
Refrigerator display.
2. Use the Freezer (+) or (-) touch pads to scroll through the
preference names. When the desired preference name isdisplayed,
press the Refrigerator (+) or (-) touch pads to change the
preference status.
3. Set your preferences by pressing and holdingthe Door Alarm touch
pad for 3 seconds, or by shutting the refrigerator compartment door.
198