Filter
Top Products
9
Style 2: Direct wire strain relief
■ Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
■ Position cord/conduit plate as shown in the following
illustration.
■ Replace cord/conduit plate and insert screws.
■ Assemble a UL listed conduit connector in the opening.
■ Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
■ Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
A.Removable retaining nut
B.Strain relief
A
B