Whirlpool GR475LXK Range User Manual


 
11
ELECTRONIC OVEN CONTROL
Display
When power is first supplied to the appliance, PF will appear on
the display. Press OFF/CANCEL to clear.
Any other time PF appears, a power failure has occurred. Press
OFF/CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When using COOK TIME (on some models,) the display will show
either hours and minutes, or minutes and seconds.
Start
The START pad begins any oven function. If not pressed within 5
seconds after pressing a function pad, the START? indicator
light will flash as a reminder. On some models, START? will
appear on the display.
If not pressed within 4 to 5 minutes (depending on your model)
after pressing a function pad, the oven display will return to the
time of day mode and the programmed function will be
cancelled.
Off/Cancel
The OFF/CANCEL pad stops any function except the WARMING
DRAWER, Timer and Control Lock.
Clock
To Set :
Before setting, make sure the oven and Timer are off.
1.
Press CLOCK.
2.
Press the HR or MIN up or down arrow pads to set the
time of day, including a.m. or p.m.
3.
Press CLOCK or START.
Tones
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End-of-cycle
Reminder, repeating each minute after the end-of-cycle tones
Reminder Tones
Reminder tones may be turned off. Press and hold STOP TIME
for 5 seconds. rEP will appear in the 3-digit display and OFF
will appear in the 4-digit display. Repeat to turn reminder tones
back on.
All Tones
All of the above tones are preset on, all except the end-of-cycle
tones can be turned off.
To Turn Off/On:
Press and hold START TIME for 5 seconds. A
tone will sound and Snd OFF will appear on the display. Repeat
to turn tones on and Snd on will appear on the display.
Tone Pitch (on some models)
The pitch is preset at high, but can be changed to low.
To Change:
Press and hold WARMING DRAWER for 5 seconds.
A tone will sound and Snd LO will appear on the display.
Repeat to change and Snd Hi will appear on display.
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change:
Press and hold CUSTOM BROIL for 5 seconds. A
tone will sound and “°C will appear on the display. Repeat to
change back to Fahrenheit. To exit mode, press OFF/CANCEL.
1.
Display
2.
Timer
3.
Clock
4.
Auto Clean
5.
Oven Light Pad
6.
Sequence Programming
(on some models)
7.
Oven Settings
8.
Warming Drawer
(on some models)
9.
Temperature
10.
Timed Cooking
11.
Hour/Minute
12.
Start/Control Lock
13.
Off/Cancel
B
C
E
S A