Filter
Top Products
12
Locked
Use Locked to avoid unintended use of the dishwasher. You can
also use the Locked feature to avoid unintended cycle or option
changes during a cycle.
NOTE: When Locked is lit, all buttons are disabled.
To lock the controls
Press and hold
for 5 seconds. Locked glows. If you press any pad while your
dishwasher is locked, the light flashes 3 times.
To unlock the controls
Press and hold HEATED DRY for 5 seconds until the light turns
off.
NOTE: The dishwasher door can be opened while the controls
are locked.
Delay Hours
Use Delay Hours to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
To delay the start
1. Close the door.
2. Press DELAY 1 time for a 2-hour delay, 2 times for a 4-hour
delay, or 3 times for a 6-hour delay.
3. Select a wash cycle and option.
The number glows above Delay or 4 Hour Delay. The dishwasher
starts the cycle in the selected number of hours. If you do not
press a cycle within 30 seconds, the Delay or 4 Hour Delay
indicator turns off.
NOTES:
■ To cancel the delay and cycle, press CANCEL/DRAIN.
■ To cancel the delay and start the cycle, press START/
RESUME.
Cycle Status Indicators
Follow the progress of your dishwasher with the Cycle Status
Indicators. Clean glows when a cycle is finished. The light turns
off when you open the door or press CANCEL/DRAIN.
Washing
Washing glows while the dishwasher is washing or rinsing the
dishes.
Drying
Drying glows while the dishwasher is drying your dishes.
Clean
Clean glows when a cycle is finished. The light turns off when you
open the door or press CANCEL/DRAIN.
Drying System
During drying, you can see steam escaping through the vent at
the upper left corner of the door. This is normal as the heat dries
your dishes.
IMPORTANT: The vapor is hot. Do not touch the vent
during drying.
Overfill Protection Float
The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.
Check under the float for objects that may keep the protector
from moving up or down.