Filter
Top Products
INSTALLING THE UNIT IN CABINET
The doors should be removed to decrease the weight 0.’ the oven and provide a better hand hold on the
oven while lifting it into the cabinet,
A. To Remove Doors (See Fig. 1)
Use caution! Oven door is heavy.
1. Open door completely.
2. Depress finger tab in oven door hinge area. Push tab toward
oven. Lift tab away from door liner and slide toward top of
oven door.
3. Repeat step 2 for other side of door.
4. Close door until approximately 5 inches from Fully closed
position.
5. Slide door off the hinge arm assemblies.
6. Repeat steps 1 through 5 for other door on dcuble ovens.
Be sure that phenolic spacers at either side of oven are in place to
provide proper air flow between cabinet and oven.
When oven has been place into cabinet, the bottom trim strip is
placed on lower edge of front frame. This is done by lcosening the
three screws at the bottom of the front frame. Slide tl-e trim strip
under the screw heads until the strip meets the lower ccrners of the
front frame (See Fig. 2). Tighten screws to hold to front frame.
Secure oven to cabinet with # 8 screws provided. Do not over-tighten
screws. Edge of front frame should be parallel to cabinet. Disregard
any excess screws that are left after all screw holes in front frame
have been used.
I
B. Replace Oven Racks in Oven Cavity.
C. Reinstall The Door(s) (See Fig. 1)
1. Slide door hinge arms until firmly seated.
2. Lower door to full open position.
3. Push finger tabs to back. Depress the tabs and slide forward.
4. Close and reopen door slowly to make sure it has been
replaced properly.
5. Repeat steps 1 through 4 for other door on double oven.
DOOR ADJUSTMEblT CHECK
A
NEWSPAPER
STRIPS
TOP OF DOOR
NEWSPAPER !tTRIPS
SIDE OF I OOR
NEWSPAPER STRIPS
BOTTOM OF DOOR
w ADJUST IN i
ADJUST UP OR
DOWN3
TO ALIGN DOOR
Place 2” x 18” strips of newspaper in lo-
cations indicated by illustration. Allow one
end of the paper to extend into the oven
cavity. Pull gently at each piece of paper. If
door is properly adjusted, each piece of
paper will offer firm resistance when pulled.
When door is out of adjustment. slide unit
out far enough to expose hinges on each
side. Loosen screws and move bottom of
door to a proper fit. After completing ad-
justment tighten all screws in hinges.
Specifications Subject to Change Without Notice
FORM 15922A
q 17-n 8J
PRINTED IN U.S.A.