Filter
Top Products
23
*Always refer to Service Sheet and Use and Care Manual for information specic to the refrigerator you are servicing.
KitchenAid Stealth Control Overview and
Programming Instructions (continued)
ICE MODE LIGHT
MAX ICE
LOCK
Hold 3 Sec.
TEMPERATURE
Hold 3 Sec.
RESET FILTER
Hold 3 Sec.
Back Units Select Zone
-
+
Refrigerator
Recommended Setting
Confirm
Lower
Raise
Adjusting Temperature Settings
Press the LOCK pad to raise the temperature set point or press the MAX ICE pad to lower the
temperature set point. See figure 8.
Important: When the temperature is changed, the word “ CONFIRM” above the lter reset pad
illuminates and will FLASH without an audible tone constantly until user presses RESET FILTER,
ICE MODE or after 60 seconds of inactivity. If the user presses TEMPERATURE to change
compartments, C
ON
FIRM still flashes if one of the temps has been changed.
NOTE: To view Celsius temperatures, press the LIGHT button when adjust mode is activated. To
return the display setting to Fahrenheit, press LIGHT again
.
.
Figure 8
Freezer Temperature Setting
After viewing (and adjusting if desired) the refrigerator set point, press TEMPERATURE to
change the display to show the freezer set point. When the zone has been changed, “FREEZER”
appears o
n th
e display screen. Press LOCK to raise the set point, or press MAX ICE to lower the
set point. When you have finished viewing (and adjusting if desired) both the refrigerator and
freezer set points, press FILTER to save the settings. See figure 9.
Figure 9
ICE MODE LIGHT
MAX ICE
LOCK
Hold 3 Sec.
TEMPERATURE
Hold 3 Sec.
RESET FILTER
Hold 3 Sec.
Back Units Select Zone
-
+
Freezer
Recommended Setting
Confirm
Lower
Raise
Save
Adjusting Temperature Settings
Press the LOCK pad to raise the temperature set point or press
t h e M A X I C E p a d t o l o w e r t h e t e m p e r a t u r e s e t p o i n t . S e e g u r e 8 .
Important: When the temperature is changed, the word “ CONFIRM” above the lter reset
pad illuminates and will FLASH without an audible tone constantly until user presses RESET
FILTER, ICE MODE or after 60 seconds of inactivity. If the user presses TEMPERATURE
t o c h a n g e c o m p a r t m e n t s , C O N F I R M s t i l l a s h e s i f o n e o f t h e t e m p s h a s b e e n c h a n g e d .
NOTE: To view Celsius temperatures, press the LIGHT button when adjust mode is activat-
ed. To return the display setting to Fahrenheit, press LIGHT again
.
Freezer Temperature Setting
After viewing (and adjusting if desired) the refrigerator set point, press TEMPERATURE
to change the display to show the freezer set point. When the zone has been changed,
“FREEZER” appears on the display screen. Press LOCK to raise the set point, or press
MAX ICE to lower the set point. When you have nished viewing (and adjusting if de-
sired) both the refrigerator and freezer set points, press FILTER to save the settings.
See gure 9.