Filter
Top Products
Fan and light Pads
Cl
The six pads at the bottom of the control panel
control the 2-Speed Exhaust Fan and the Cook-
top Light.
Once you’ve touched a Command Pad to tell
the oven what you want it to do, you’ll touch
Number Pads to tell it...
-a time.
- a Cook Power.
- a food temperature.
Touch Fan Pad for the desired fan speed.
(NOTE: If the temperature gets too hot around
the microwave oven, the exhaust fan in the
vent hood will automatically turn on or
change to the HIGH oefflng to protect the
oven. It may stay on up to an hour to cool the
oven. When ff~ls occurs, the Fan Pad will not
turn the fan off.)
Touch Light Pad for the desired cooktop or
countertop lighting.
Audible Signals
Audible signals are available to guide you when setting and using your oven. [A programming tone will
sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound
every 30 seconds after cooking is done to remind you that something has been left in the oven. A 3 second
tone signals the end of the Minute Timer function.] If you don’t hear a tone, it is because of incorrectly
entered instructions or because the tones have been removed. For example, a tone will not sound if you
touch a Number Pad before you touch a Command Pad.
To remove fhe programming tone and reminder
To remove all tones, except the Minute Timer
tone:
signal:
l
Open the door.
l
Open the door.
l
Touch CANCEL
twice,
then touch START.
l
Touch CANCEL
twice,
touch 0, then touch START.
l
Programming and reminder tones will be
l
All audible tones (except Minute Timer signal)
cancelled.
will be cancelled.
To replace the tones:
To replace the tones:
l
Repeat the steps above.
l
Repeat the steps above.
Setting the Clock
When the oven is first plugged in, a tone sounds and the Display shows “88:881’ If the
electric
power
ever goes off, the Display will again show all 8’s when the power comes
back on.
You can cook
or
use the Minute Timer without setting the Clock, but the Display will be
blank after cooking.
DO THIS...
THIS HAPPENS...
.
Hi
1. Touch CLOCK SET.
The Display will show a “0” and
the colon will start to flash. The
flrsf Number Pad must be touched
wlthln 5 seconds or the Display will
go blank.
Touch CLOCK SET again
and continue.
6