Filter
Top Products
7
Display
When power is first supplied to the microwave oven, a “:” will
blink on the display. Touch CANCEL to stop the blinking. If the “:”
blinks on the display at any other time, a power failure has
occurred. Touch CANCEL and reset the clock if needed.
If “RETRY” blinks on the display for 1 second, an invalid value
has been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day or Timer
countdown.
Number Codes
The microwave oven is preset with shortcut number codes. A
number code includes one or more of the following: cooking
power, cook time and food quantity or weight. See the charts in
the “Cooking” and/or “Reheating” sections for additional
information.
Start/Add 30 Seconds
The START control shares function with the Add 30 Seconds
feature. The START pad will start any function. If not touched
within 5 seconds after touching a pad, “START?” will appear on
the display as a reminder. If not touched within 5 minutes after
touching a pad, the display will return to the time of day mode
and the programmed function will be canceled.
If cooking is interrupted, touching the START will resume the
preset cycle.
The ADD 30 SEC. control starts the oven at 100% power for
30 seconds, and adds 30 seconds of cook time with each
additional touch of the control. Once cooking begins, cook power
or cook time may be changed manually by touching the
appropriate display area and entering the new setting.
Easy Minute Feature
The numerical pads 1-5 share function with the Easy Minute
controls. When one of these controls is touched (while no
function is operating), the oven will begin cooking at high power
for 1-5 minutes, depending on which pad is touched. After
cooking begins, the Easy Minute controls return to their normal
numerical pad function.
Cancel
The CANCEL pad stops most functions except for the Timer,
Child Lock and Demo Mode.
The microwave oven will also turn off when the door is opened.
Close the door and touch START control to resume the cycle. A
sensor cooking cycle may not be resumed if interrupted by
opening the door.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
The microwave oven and timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear, and “:” will appear on the display.
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid entry (short tone)
■ End of Timer countdown (long tone)
Two tones
■ Reminder, repeat each minute after the end-of-cycle tones
■ End of stage in multistage cooking
■ Hidden feature has been entered or exited
Three tones
■ Invalid entry
Four tones
■ End of cycle
To Turn Off/On Valid Entry Tones: Touch and hold the number
pad “1” for 5 seconds until 2 tones sound. Repeat to turn tones
back on.
To Turn Off/On All Tones: Touch and hold the number pad “2”
for 5 seconds until 2 tones sound. Repeat to turn tones back on.