Filter
Top Products
STEP 5
I.
2.
3.
4.
5.
Place microwave oven in the opening
of the cut-out. Be careful nof to
bend the Anti-Tip Flange.
Flange
musl be flat lo cut-out floor to
engage correctly with Anti-Tip
Bracket as shown.
Plug in microwave oven.
Cenler microwave oven within
the cut-out opening and slide
oven in place.
After oven is in place, ensure
microwave is accurately
centered.
Drill pilot holes through
Positioning Flanges and install
Low Profile Strews(2) at the
front of the Ducts as shown.
Antl-Tip Assembly
STEP 6
Low Profile
Screws
L Flange
cutout
Opening
Posilionina
Flanges -
7 STEP
1.
Place Trim Frame over the microwave.
Make sure microwave is centered within
the Frame. Firmly push Frame against
the wall at the four Spring Clip
locations as shown.
2.
Check Frame for
tight fil.
If Frame
is loose, remove the Frame and make
necessary adjustments by loosening the
Screws, re-posthoning the Clips and
m-tightening the Screws. &-attach
Frame as above.
PART NO. 4313741
1. Mark center positions (or center punch) for
the pilot holes(4) as shown. Dim.A is
measured from the cut-out bottom and
Dim.B is from the cut-out side. The
top hole is determined by Dim.C.
Dlm.A = ‘I,,,-
Dlm.B = ‘/,’ (mln.)
Dlm.C = 16 %’
Top Clip PoSitIon
a~jfY:.FjnDim. c
-s
2. Drill pilot holes and install the Spring
Clips(4) using Low Profile Strews(4).
Note that the top Clips face up and
the bottom Clips face down as shown.
3. The Spring Clips are provided with a
Position
Opening
slotted hole for fine adjustments as required.
6 STEP
1.
Your Trim-Kit is now fully
Installed. Replace any loose
items that might have been
removed from the oven.
2. Please keep this installation
instruction for Mure reference.
Page 2