Filter
Top Products
Replacing the light bulb
1. Unplug the power cord.
2. Remove screw on access panel.
3. Unscrew the light bulb from its socket.
4. Replace bulb with a ISwatt candelabra base
bulb.
5. Replace the access panel and screw
6. Plug in the power cord.
ACCESS
PANEL
Installation instructions
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
Installing your microwave oven
1. Empty the microwave oven and clean inside it
with a soft, damp cloth. Check for damage such
as misaligned door, damage around the door or
dents inside the oven or on the exterior. If there is
any damage, do not operate the unit until it has
been checked by an authorized Whirlpool serv-
ice technician and
any repair made.
3. Db n6t btbck the vent or alr intake open-
ings on the rear of the oven. Blocking vent or air
intake openings can cause damage to the
oven and poor cooking results. Make sure the
microwave oven legs are in place to ensure
proper air flow.
2. Put the oven on a cart, counter, table or shelf
that is strong enough to hold the oven and the
food and utensils you put in it. (The control side 01
the unit is the heavy side. Use care when han-
dling.) The weight of the oven is approximately
33 Ibs. (15.0 kg.).
SIDE
2 inches
4. Do not Install the microwave oven so
that both sides and the top are flush with
walls, shelves or cabinets. Leave clear-
ance of at least 2 in. (5.08 cm] on the left
side and 1 in. (2.54 cm) on the top and right
side for proper operation.
Do not install the oven next to or over a
conventional surface unit or in any
area where excessive heat and steam
are generated. This could damage
the microwave oven.