Filter
Top Products
Building in your microwave oven
Your microwave oven is not limited to carts, counters ortables. Custom installations are made
easy with kits available from your dealer.
1.
Build the microwave oven into a cabinet or Ask your dealer for details on...
wall by itself or over built-in single ovens in the
l
832978 -30-inch Built-in Kit
Whirlpool RDE, REE, RGE, RB and SB model series.
l
832989 - 24-inch Built-in Kit
2. Attach the microwave oven to a wall by itself
l
832991 -27-inch Built-in Kit
or with cabinets over it.
. 832993
Wall Mounting Kit
3. Put the microwave oven on the MICRO SHELF@
l
RH3330XR - MICRO SHELF@ Hood
Hoob over a cooktop. The hood is available
Use only approved installation kits.
ducted or as a recirculating hood, and includes
Obtain these kits from your authorized
cooktop lights.
Whirlpool dealer.
Caring for your microwave oven
Cleaning the microwave oven
Wipe often with warm sudsy
water and a soft cloth or
sponge
For stubborn soil, boil a cup
of water In the oven for 2 or 3
minutes Steam
will
soften
the soil
Be sure to cle6n the areas
where the door and ov8n
frame touch when closed.
When cleaning’surfaces of
door and oven that come to-
gether on closing the door,
use only mild, non-abrasive
soaps or deteraents aoolied
wtth’o sponge& soft dlbth.
Rinse well.
Cautlon:
Abrasive cleansers, steel wool pads, gritry wash cloths, etc.. con damage the control
panel, electronics, and the interior and exterior oven
SurfaCes.
Use a soft cloth or a
sponge with a mild detergent or spray glass
Cleaner.
Replacing the light bulb
The microwave oven light should come on whenever the door is opened or the oven is operating.
To replace:
1.
Unplug, or turn off at fuse box or circuit
breaker.
2.
Open the oven door.
3. Remove the 3 screws from the front of the
cover.
4. Pull down the front portion of the cover.
(It is creased across its width to form a
hinge.]
5. Remove and replace the 25watt candelabra-
base bulb (FSP 313760). Obtain bulb from
your authorized Whirlpool dealer.
6.
Close the cover and replace the screws.
7. Plug in, or turn on the main power supply.