Filter
Top Products
Using your microwave oven
Microwave oven controls
There are three parts in the control section:
-The Digital Display/Clock, and Signal
Lights
-Command Pads
- Number Pads
Instructions for each control are covered on the
following pages. Read them carefully.
When you first plug in the oven, the Display
will show 88:88. If. after you set the Clock
(page6], the Display again shows all 8’s, it
means your electricity was off for a while.
Reset the Clock.
Digital display/clock and signal lights
When you are not
using the microwave
oven, this is an accu-
rate digital clock.
When you are using
the microwave oven,
this displays time and
Cook Power settings,
signal lights and
shows you what
Number Pads you
Command pads
touched.
q
Touch Command
.a
Pads to tell the
. . -
microwave oven
what to do and in
what order. A few
examples:
-CLOCK SET tells
the oven YOU
are
oven to start See
page 13for information on the tone you hear
when touching any pad.
Each Command Pad (except START and
CANCEL) lights a Signal Light on the digital
display. The Signal Light comes on when
you touch the Command Pad.
While the oven is running, a Signal Light
(or lights] will be on to show what the oven
is doing.
Number pads
- a time,
p p m -a CookPower.