Filter
Top Products
Install properly.. .
Remove sales labels.. .
1. Allow 3 inches (7.5 cm] between overhead cab-
inets and the refrrgerator top.
2.
Allow at least an inch (2.5 cm] between the refrig-
erator condenser and the wall.
3. Allow % inch (1.25 cm) on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
wont to leave enough space so the door can be
opened wider.
Level refrigerator-freezer...
Leveling screw
Use Screwdriver
to Adjust
1. To raise front, turn each screw to the right
2. To lower front, turn each screw to the left.
3. Check with level.
4
Remove the Consumer Buy Guide label and other
inside labels before using the refrigerator. Any glue
left can be taken off with rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator before using it. See clean-
ing instructions on page 8.
Plug it in...
grounding type
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See
individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.