Filter
Top Products
Before Using Your
Refrigerator
In This Section
Page
Page
Cleaning
your refrigerator . . . . . . . . . . . . . . . . .
5
Installing it properly . . . . . . . . . . . . . . . . . . . . m . . . . . .
6
Plugging
it in . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5 Leveling it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
Cleaning your refrigerator
Removing packaging materials
NOTE: Do not remove any permanent
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining glue:
l Rub briskly with thumb to make a ball,
then remove.
OR
l Soak area with liquid hand-dishwashing
detergent before removing glue as
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners. These can
damage the material. See “Important
Safety Instructions” on page 3.
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 12-l 3.
Plugging it in
Recommended Grounding Method
A 115 Volt/GO Hz (Plug l), 220/240 Volt/50
Hz (Plug 2) or 220 Volt/GO Hz (Plug 3) AC
only 15 or 20 ampere fused and properly
grounded electrical supply is required. It is
recommended that a separate circuit serving
only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Plug 1
Plug 2
Plug 3
5