Filter
Top Products
Removing meat drawer and
cOver
To
remove meat drawer:
1. Slide out to the stop.
2. Lift the front.
3. Shde out the rest of the way.
4. Replace in reverse order.
To remove cover:
1. Tilt front of cover up, lift at back
and pull straight out.
2. Replace in reverse order.
Removing crispers and
crisper cover
To
remove uisper:
1. Slide out to the stop.
2. Lift the front.
3. Slide out the rest of the way.
4. Replace in reverse order.
To
remove cover:
1. Push up glass insert from bottom,
then lift out with two hands.
2. Lift front of cover frame.
3. Pull cover frame up and out.
4. Remove metal cover support.
To replace wver:
1. Replace metal cover support on
wall supports in front section of
cabinet.
2. Fit back of cover frame into notch
supports on walls of refrigerator,
then lower into place.
3. Slide back of glass insert into place,
then lower front.
Removing freezer basket
-nu
To change freezer light:
1. Disconnect refrigerator from power
-..--1w.
To remove
basket:
1. Slide out to the stop.
2. Lift the front to clear
the
stop.
3. Slide out the rest of the way.
To replace
basket:
1. Place basket on the slides.
2. Make sure the wire stops clear the
front of the slides.
3. Slide basket in.
Changing the light bulbs
I
mectricaIshfxkHazard
I
Unplug the refigerator or discon-
nect the main electric power supPly
to the reftigerator before changing
a
~ bulb. Failure to do BO could result in
electrical shock or MUIY.
2. Push in sides of light shield until it
snaps free.
3. Replace bulb with a 40-watt
appliance bulb.
4. Snap light shield into place.
5. Reconnect power supply.
NOTE: Not all commercial appliance
bulbs will fit your refrigerator. Be sure to
replace a bulb with one of the same size
and shape.
Removing the base grille
To
remove fpille:
1. Open freezer door.
2. Pull grille out.
2. Push lightly on the top center of the
light shield until the notched tab
unhooks from the control nanel.
To change refrigerator light:
1. Disconnect refrigerator from power
supply.
3. Do not remove Tech Sheet
fastened bebind grille.
See cleaning insmctions for defrost pan
To replace grille:
1. Line up grille support tabs with
and condenser coils on page 7.
metal clips.
2. Push firmly to snap into place.
3. Close the door.
3. Pull down on the light shield until
Reversing the door swing
the tab clears the control panel.
4. Lift back hooks out of their slots.
5. Remove bulb and replace with a
40-watt appliance bulb.
6. Replace light shield in reverse
order.
7. Reconnect power supply.
You can change the hinges on your
refrigerator so the doors open the other
way. Refer to the instruction sheet
included with
your
refrigerator.
Ice cube trays
Remove ice by slightly twisting the tray
with both hands.
NOTE: The longer ice cubes are stored,
the smaller they get. Slow evaporation is
caused by the movement of cold air.
Page 5