7
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Press and hold the DELAY START TIME pad for 5
seconds. A tone will sound and “Snd Hi” and “Snd Lo” will
remain on the oven display. To remove, press UPPER OFF,
LOWER OFF or OFF/CANCEL. Repeat to change back to
“Snd HI.”
REMINDER TONES
The Timer and Timed Cooking reminder tones are preset on, but
can be turned off. Reminder tones do not include end-of-cycle
tones. If “All Tones” have been turned off, the reminder tones
cannot be independently turned on.
Timer
To Turn Tones Off/On: Press and hold TIMER SET until a tone
sounds. The display will show “TIMER” and “NA9 On” or
“TIMER” and “NA9 OFF.” To remove from the display, press
UPPER OFF, LOWER OFF or OFF/CANCEL. Repeat to turn
back on.
Timed Cooking
To Turn Tones Off/On: Press and hold COOK TIME until a tone
sounds. The display will show “COOK TIME” and “NA9 OFF” or
“COOK TIME” and “NA9 On” to indicate the status of the cook
time tones. To remove from the display, press UPPER OFF,
LOWER OFF or OFF/CANCEL. Repeat to turn back on.
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Touch and hold CUSTOM BROIL for 5 seconds. A
tone will sound and “C” will appear on the display. Repeat to
change back to Fahrenheit. To remove, touch UPPER OFF,
LOWER OFF or OFF/CANCEL.
Timer
The Timer can be set in hours and minutes and counts down the
set time. The Timer does not start or stop the oven.
To Set:
1. Press TIMER SET.
If no action is taken after 4 minutes, the electronic oven
display will return to the time of day mode.
2. Press the HR or MIN “up” or “down” arrow pads to set length
of time.
3. Press TIMER SET or START/ENTER.
If not pressed within 4 minutes, the display will return to the
time of day mode and the programmed function will be
canceled.
When the set time ends, if enabled, end-of-cycle tones will
sound, then reminder tones will sound every minute.
4. Press TIMER OFF anytime to cancel the Timer and/or stop
reminder tones.
Remember, do not press the Off/Cancel pads because the
respective oven will turn off.
The time can be reset during the countdown by repeating the
above steps.
Control Lock
The Control Lock shuts down the control panel pads to prevent
unintended use of the ovens.
When the control is locked, only the CLOCK, TIMER SET and
TIMER OFF pads will function.
The Control Lock is preset unlocked, but can be locked.
To Lock/Unlock Control: Before locking, make sure the ovens,
Timer and Timed Cooking are off. Press and hold START/ENTER
until a single tone sounds and “Loc,” a picture of a lock and
“START?” will appear on the oven display, about 5 seconds.
Repeat to unlock and remove “Loc” from display.
Oven Temperature Control
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door and element or
burner cycling may give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
A minus sign means the oven will be cooler by the displayed
amount. No sign means the oven will be warmer by the displayed
amount. Use the following chart as a guide.
To Adjust Oven Temperature Calibration:
1. Press and hold BAKE until the oven display shows the current
calibration, for example, “0° CAL.”
2. On double oven models only, press UPPER OVEN or LOWER
OVEN.
3. Press the TEMP “up” or “down” arrow pad to increase or to
decrease the temperature in 10°F (5°C) amounts. The
adjustment can be set between 30°F (15°C) and -30°F
(-15°C).
4. Press START/ENTER.
ADJUSTMENT °F
(ADJUSTMENT °C)
COOKS FOOD
10°F (5°C) ...a little more
20°F (10°C) ...moderately more
30°F (15°C) ...much more
-10°F (-5°C) ...a little less
-20°F (-10°C) ...moderately less
-30°F (-15°C) ...much less