Whirlpool RBD276 Oven User Manual


 
13
OVEN AND ROASTING RACKS
Self-Cleaning cycle:
See “Self-Cleaning Cycle” first. Remove racks or they will
discolor and become harder to slide. If this happens, a light
coating of vegetable oil applied to the rack guides will help
them slide.
Steel wool pad
BROILER PAN AND GRID
Do not clean in the Self-Cleaning cycle.
Mildly abrasive cleanser:
Scrub with wet scouring pad.
Solution of ¹₂ cup (125 mL) ammonia to 1 gal. (3.75 L) water:
Soak for 20 minutes, then scrub with scouring or steel wool
pad.
Oven cleaner:
Follow product label instructions.
Porcelain enamel only, not chrome
Dishwasher
Oven Lights
The oven lights are standard 40-watt appliance bulbs. They will
come on when the oven door is opened. On double oven models
with self-clean upper and lower ovens, all oven lights will come
on when either door is opened. On double oven models with
standard-clean lower ovens, the oven lights will not come on
when the lower oven door is opened. The oven lights will not
work during the Self-Cleaning cycle. When the oven door is
closed, touch LIGHT to turn them on or off.
To Replace:
Before replacing, make sure the oven is off and cool.
1. Disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if necessary, follow these instructions. The oven
door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a “click” as the door is set into place.
3. Move the hinge levers back to the locked position. Ensure
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.