Whirlpool RBS275 Oven User Manual


 
6
ELECTRONIC OVEN CONTROL
Display
When power is first supplied to the appliance, everything on the
display will light up for 5 seconds. Then, the time of day and “PF”
will appear on the electronic oven display.
Any other time “PF” appears, a power failure occurred. To reset
the clock, press UPPER OFF or LOWER OFF on double oven
models. On single oven models, press OFF/CANCEL.
Electronic Display
When the oven(s) are in use, this display shows the oven
temperature. On double oven models, this display will also show
which oven is being set. The left cavity symbol represents the
upper oven and the right cavity symbol represents the lower
oven.
If “Err” appears on the oven display, an invalid pad was pressed.
Press UPPER OFF or LOWER OFF and retry entry. On single oven
models, press OFF/CANCEL.
When the ovens are not in use, the display will show the time of
day.
Start/Enter
The START/ENTER pad begins any oven function except the
Timer. If not pressed within 5 seconds after pressing a pad,
“START?” will appear on the oven display as a reminder. If not
pressed within 5 minutes after pressing a pad, the oven display
will return to the time of day mode and the programmed function
will be cancelled.
Upper Off, Lower Off or Off/Cancel
The UPPER OFF, LOWER OFF and OFF/CANCEL pads stop their
respective oven functions except for the Clock, Timer and
Control Lock.
The cooling fan may continue to operate even after an oven
function has been cancelled, depending on the oven
temperature.
Clock
This is a 12 hour clock and does not show a.m. or p.m.
To Se t:
Before setting, make sure the ovens, Timer and Timed Cooking
are off.
1. Press CLOCK.
2. Press the HR or MIN “up” or “down” arrow pads to set the
time of day.
3. Press CLOCK or START/ENTER.
To remove the time of day from the display: Press and hold
CLOCK for 5 seconds.
To return the time of day to the display: Press CLOCK. The
time should not have to be reset.
Tones
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End-of-cycle
Reminder, repeating each minute after the end-of-cycle tones
All Tones
All of the above tones are preset on, but can be turned off.
To Tur n Off/ On: Press and hold STOP TIME for 5 seconds, and a
tone will sound. On double ovens only, “Snd oFF” will appear on
the oven display for 3 seconds. Repeat to change back to “Snd
on”.
1. Upper Oven Temperature Display
2. Electronic Display
3. Lower Oven Temperature Display
4. Timer
5. Clock
6. Oven Light
7. Oven Selector
8. Oven Settings
9. Temperature Setting
10. Timed Cooking
11. Hour
12. Minute
13. Start/Enter [Control Lock]
14. Off/Cancel